By:
In: Laser Cutters & Engravers

Buy the machine that matches what you actually want to make, not the one that sounds cooler. Why this matters I get asked this all the time. Someone walks into the shop, sees both my CO2 and fiber lasers running, and wants to know which one they should buy first. The answer is always the same: what are you planning to cut or engrave today, not six months from now when you might be doing something different. The internet makes this decision worse than it needs to be. You’ll read that fiber is the future or that CO2 is dead or that you need both.KEEP READING →

By:
In: Laser Cutters & Engravers

Your laser is burning uneven cuts and you know the mirrors are off, but you’d rather rebuild the whole machine than break out a protractor. Why This Matters Mirror alignment sounds technical but it’s just geometry you can see with tape. If your beam isn’t hitting the center of each mirror at every corner of the bed, your cuts will be weak on one side or burn through on the other. You waste material. You waste time. You ruin jobs. I avoided mirror alignment for months when I first got my CO2 laser. I thought I needed special tools or had to understand physics. ThenKEEP READING →