By:
In: Laser Cutters & Engravers

I got tired of watching people buy a laser and then spend three months trying to figure out how to make money with it. The gap nobody talks about You unbox a Monport. You follow the manual. You run the test file. Then what? The manual tells you how to turn it on. It does not tell you how to align mirrors when your cuts look like garbage. It does not explain why air assist matters or how to set it for different materials. It definitely does not walk you through your first paying job. So you end up in Facebook groups asking the sameKEEP READING →

By:
In: Laser Cutters & Engravers

Your laser is burning uneven cuts and you know the mirrors are off, but you’d rather rebuild the whole machine than break out a protractor. Why This Matters Mirror alignment sounds technical but it’s just geometry you can see with tape. If your beam isn’t hitting the center of each mirror at every corner of the bed, your cuts will be weak on one side or burn through on the other. You waste material. You waste time. You ruin jobs. I avoided mirror alignment for months when I first got my CO2 laser. I thought I needed special tools or had to understand physics. ThenKEEP READING →

By:
In: Laser Cutters & Engravers

You’ve seen the “pay off your laser in 30 days” posts, and honestly, most of them are full of it. Why This Matters I see these viral posts all the time. Someone buys a laser on Monday, films themselves working 18-hour days, and claims they paid off a $4,000 machine by Friday. The comments are full of people asking “how did you do it?” and the answer is always vague motivation instead of actual steps. Here’s what they don’t show you. The prep work they did before they even ordered the laser. The existing customer base from another business. The spouse covering bills while theyKEEP READING →

By:
In: Laser Cutters & Engravers

Your laser just showed up and the manual assumes you already know what you’re doing. Why This Matters I’ve unboxed four Monport lasers at this point. Two CO2 machines and two fiber units. Every single one arrived with at least three things the manual skipped or buried in bad translation. The manual tells you to “install the machine” and “check all connections.” That’s not helpful when you’re staring at 200 pounds of equipment in your driveway and you’ve never owned a laser before. This is what I wish someone told me before I fired up my first Monport. These are the things that will saveKEEP READING →